NEED ADVICE ON REPLACING AN OLD LEAKY ROOF
Couldn’t agree more about the “premium” upgrades—most of them just pad the bill. I’ve seen plenty of roofs last decades with basic vents and solid shingles. Unless you’re in some extreme climate or have a super complicated roofline, I’d rather spend on good underlayment and proper flashing. That’s what really keeps water out. Fancy vents are like chrome rims on a work truck...nice to look at, but not doing much for the job.
NEED ADVICE ON REPLACING AN OLD LEAKY ROOF
I hear you on the “premium” stuff—sometimes it feels like you’re just paying for a shiny label. But have you ever run into issues with basic vents in humid areas? I had one project where mold crept in because the airflow wasn’t quite enough... Maybe that’s just a fluke, though. Curious if anyone else has seen that or if I just got unlucky.
NEED ADVICE ON REPLACING AN OLD LEAKY ROOF
I’ve definitely seen basic vents struggle in humid climates, especially if the attic’s packed with insulation or the roof pitch is low. Mold’s a real risk if the airflow can’t keep up. Sometimes it’s not just the vent type, but also how many you’ve got and where they’re placed. I had a builder once try to save a buck with fewer vents—ended up costing way more in repairs later. Maybe not a total fluke in your case.
NEED ADVICE ON REPLACING AN OLD LEAKY ROOF
I’ve dealt with this exact headache on a high-end remodel a couple years back. Builder tried to convince me “standard” vents were fine, but the attic was basically a sauna every summer. Ended up ripping out half the ceiling because of mold—total nightmare. If you’re already replacing the roof, don’t cheap out on ventilation or placement. It’s not just about how many vents, but making sure they actually move air where it matters. Sometimes spending more upfront is the only way to avoid those ugly surprises down the line.
NEED ADVICE ON REPLACING AN OLD LEAKY ROOF
Had a similar situation a few years ago—old roof, bad leaks, and the attic was like a steam room. I went with what the roofer called “adequate” ventilation, but honestly, it didn’t cut it. Ended up with condensation issues that took forever to trace back. Did you look into ridge vents or any kind of powered ventilation? I always wonder if those are worth the extra cost or just marketing hype...
