...every time I do it, there’s always some unexpected hiccup... last time, the drain didn’t line up and I had to make a late-night hardware run.
That’s the part they never show—lining up the drain with existing plumbing is rarely a one-to-one fit. I like to dry-fit everything before sealing, but even then, something gets in the way. Have you ever tried using flexible drain couplers? I’ve found they save a lot of headaches when the pipes just don’t quite match. Also, curious—what method did you use to cut the sink hole? I’ve seen people use jigsaws, routers, even oscillating tools, and each seems to leave a different edge.
Honestly, I get the appeal of flexible couplers—they’re a lifesaver in a pinch—but I try to avoid them if I can. Over time, those rubber fittings can degrade, especially if you’re using hot water a lot. I usually end up reworking the rigid pipes, even if it means more time under the cabinet. As for cutting the sink hole, I’ve had the cleanest results with a jigsaw and a fine-tooth blade, but I always tape the cut line to keep chipping down. Routers are great, but they kick up a ton of dust... not my favorite.
Honestly, I’m with you on the rigid pipes. Flexible couplers just feel like a shortcut that’ll bite you later, especially in high-end kitchens where you want everything to last. I’ve had to replace a few that got soft and started leaking after a couple years—total pain. For sink holes, I’ve tried both jigsaw and router, but honestly, the dust from the router is a dealbreaker for me too. Ever tried a hole saw for corners? It’s not perfect, but sometimes it saves a bit of cleanup.
Yeah, I’ve been burned by those flexible couplers too—felt like a shortcut at the time, but ended up being more hassle than they’re worth. Rigid pipes just feel sturdier, you know? As for cutting the sink hole, I tried a hole saw once thinking it’d be cleaner, but my corners still needed a touch-up with the jigsaw. Router dust is brutal though... I had it in my socks for days. Honestly, no perfect method, just gotta pick your poison.
Honestly, I’ve had the opposite experience with flexible couplers—maybe I just got lucky, but they saved me a ton of time in a tight cabinet where rigid pipes would’ve meant tearing out half the base. I get the appeal of rigid for sturdiness, but sometimes a little give is worth it. As for the sink cutout, I’ve started using painter’s tape and a multi-tool for the corners. Still messy, but at least the dust doesn’t travel as far... or maybe I’m just getting used to living with sawdust everywhere.
