KEEPING THE COLD OUT: MY STEP-BY-STEP FOR DRAFT-PROOFING DOORS

aspenskater · 2026-03-28T19:19:36Z

Here’s how I tackled making my old back door less of a wind tunnel last winter. I’m not claiming it’s the “pro” way, but it made a noticeable difference in my heating bill, so maybe it’ll help someone else. First thing I did was check for drafts with that classic candle trick (hold a lit candle near the edges and see if the flame dances). My door was leaking air all around the frame and especially at the bottom—no surprise there. Next up, I grabbed some weatherstripping from the hardware store. There’s like a million types, but I went with the foam tape because it was cheap and honestly, I didn’t want to mess with anything complicated. Peeled and stuck it around the inside edge of the door frame. For the bottom, I used one of those door sweeps you screw in (the adhesive ones always peel off for me after a month or two). After that, I tightened the hinges a bit since the door was sagging and wasn’t closing flush. Didn’t realize how much that mattered until I did it—definitely helped the seal. Last step: I put a draft stopper (just an old rolled-up towel, honestly) along the bottom when it got really cold at night. Not high-tech, but it works. I’m sure there are fancier options out there—like those insulated core doors or whatever—but this was all stuff I could do with basic tools and about $20. Anyone have better tricks, or maybe a way to make it look less like I’m barricading myself in for a zombie apocalypse?

Page 23 / 23 Prev

Insulation and Energy Efficiency Measures

Last Post by writing_jon

111 Posts

107 Users

0 Reactions

908 Views

RSS

Posts: 6

writing_jon

(@writing_jon)

Active Member

Joined:

I tried doubling up once—foam tape plus a regular sweep—and honestly, it worked better than I expected, at least for a season. But after a while, the tape started peeling with all the door traffic. Has anyone found a tape that actually sticks long-term?